LED with Pushbutton in Arduino

Here we will turn on and off LED with Pushbutton in Arduino. We will learn about the working with Digital Input Pins and also about Pushbutton. Currently, we are using Arduino UNO board. You can use any Arduino/Genuino Board and perform this experiment on that. So, let’s start it.

Step 1: Required Components

LED (generic) x 1
Pushbutton Switch x 1
Breadboard x 1
Arduino UNO Board x 1
220 Ω  Resistor x 1
10k Ω  Resistor x 1
Jumper Wires

Step 2: Circuit Time

Circuit Diagram of LED with Pushbutton

Make a circuit as per the given diagram. In this when the button is pressed, the LED will turn on and the button is released, the LED will turn off. Here we have connected the Pushbutton to Pin 6 and LED is connected to Pin 13 of Arduino UNO Board.

Step 3: Code Time

This is the code for Pushbutton and LED. Here, we have declared two pins for Pushbutton and LED. In setup, the LED pin is initialized as an output pin and Pushbutton Pin is initialized as an input pin. In the loop, there are two states of Pushbutton, HIGH and LOW. When the Pushbutton state is High, the LED will turn ON and Pushbutton state is Low, the LED will turn OFF.

Step 4: Upload the code to Arduino

Upload the above-given code to the Arduino UNO Board after the components are set as per the Circuit Diagram. The LED will turn on when you press the Pushbutton and turn off when you release Pushbutton. For information about uploading code to Arduino UNO Click Here.

1 thought on “LED with Pushbutton in Arduino”

Leave a Reply